![carvewright cw005 woodworking system carvewright cw005 woodworking system](https://i.ytimg.com/vi/EHzKJ3yQ0jU/hqdefault.jpg)
This means that some functions will not be available to you when using hard plastic. The only bit currently approved for plastic is the tapered 1/16″ carving bit. Deeper carving will put excessive load on the machine by trying to push a bit through this hard material and can cause damage to the bit and/or machine. Therefore it is very important to keep any carving in plastic to less than 1/8″ deep. Note that the machine is always expecting soft material like wood as the carving medium and will automatically set the speed and feed rates based on this expectation. The great thing about cast acrylic and Corian is that they come in many different colors and opacities. Most other plastics such as Nylon, ABS and extruded acrylic (Plexiglas) tend to melt and gum up because the melting point of the material is lower than the temperature generated at the bit tip when carving. Plastic Suitable carving plastics include polycarbonate (Lexan), cast acrylic (sign makers plastic), and acrylic base (Corian or Staron).
#Carvewright cw005 woodworking system software#
The CarveWright Designer Software has several tools to control chip out to help when working across all types of wood grain. Also dry materials tend to produce a better quality finish then material with high moisture content. In most cases, feathering and chip out will increase as the grain size increases. We have found that hard materials with tight grains produce the best finishes. While we have not tested every conceivable hardwood, we have yet to find one that cannot be used in the CarveWright machine.
#Carvewright cw005 woodworking system full#
Wood The machine can carve the full range of wood types from soft pine to exotic hardwoods. At present, the CarveWright does not carve in metal, ceramic tile, stone, glass or concrete. Any materials outside these families are not to be used with the machine unless explicitly state by CarveWright. The CarveWright can work in most soft materials including wood (even exotic hardwoods), suitable plastic and foam. The larger box (10″ x 13″ x 6″) took 5 hours at BEST quality mode. For comparison, the top of the small jewelry box (8.5″ x 5.5″ x 3.5″) on the Projects/The Results page of the website took one hour to carve in NORMAL quality mode. The software will estimate total cut time when you upload the project to the memory card. Vector carvings are typically much faster than raster carvings. The path is similar to that of a plotter. A Vector carving is produced when the bit follows a 3-D path generated by the software. The path is similar to that of a dot matrix printer. Raster carvings are produced by making many small passes with the 1/16″ carving bit, building the image one line at a time. The Cutting Mode – The CarveWright produces carvings by two different cut modes raster carving and vector carving modes.The Depth of the Cut – the deeper the cut and more wood being removed increases the carve time.
![carvewright cw005 woodworking system carvewright cw005 woodworking system](https://www.carvewright.com/wp-content/uploads/2016/06/Fireplace_closeup4.jpg)
The higher the quality setting selected, the longer the project will take to run.